Hey Tex
I know you are not bias, so I would like ask your opinion. As you know I got the STM primary & secondary clutch.
These results I have so far are with only three wheels turning due to the strip axle
when throttle is stomped down on, it hits the Rev limiter @ 7k and tries to dig a hole (lots of wheel spin) in both low & high
Top speed in low was 40 mph in less than 1/2 of1/10 of a mile
In high it reaches 30 mph in about 1/4 of 1/10 of a mile, 54 mph in 2/10 of a mile, & 60 in 3/10 of a mile. I did not go for top speed due to the axle, but when I stopped, it was still pulling
On one nasty hill I made it with 3 wheels where the Rhinos & a XP800 didn't
So my questions are as follows
Do these numbers sound about right?
What RPMS should I be pulling with the throttle to the floor?
What should my top speed be in low?
What should I be pulling in the 1/4 mile mark?
What is the best way to test the clutch & what benchmarks should I be looking for?
Thanks in advance