Wildcat Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
My 700 sport needed the center bearing replaced. Got the drive shaft out. Was a total pain. Ordered a new bearing from RMATV. It’s an all balls bearing. More beefier bearing over stock. The bearing is thicker by 1/4. If I take the rubber out of the shaft. It could work but I don’t wanna offset the front diff I go to slide the drive shaft back in. And bolt the clamp it rides in and I’m off 3/16ths of inch. I don’t wanna pull the front shaft father out of the front diff to make it work. I can’t find any factory cat ones online and due to this corona virus shit. Everything’s closed.

any tips?

It sucks im quarantined and can’t ride.
 

·
Premium Member
Joined
·
718 Posts
This is the bearing 1030-30G can be found pretty easily on ebay .
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
I actually found a factory one on arctic cat parts house. Hopefully get it in this week. I’m going to get ahold of all balls and complain. It will not work. Thanks for the help. Hopefully get it going this week and enjoy the quarantine 😂
 
1 - 3 of 3 Posts
Top