[Jonny Wire]

I can not find out what error code C 1325 means. Every list I have found ends with C 1324 for the chassis codes. Anyone out there know what this one means? Thanks!

 

[st96badboy]

2014 Wildcat Service Manual

support.countrycat.com

from the 2014 manual actual page is 113 index says page 115.
I know your is 2013, but it is likely identical. (the rest are)

"Descriptionual loss.

Fault condition: EPS loss of both the vehicle speed
and the engine RPM signals has been
detected.

Possible cause:Handlebar switch in the "OFF" position,
the engine stalled (keyswitch "ON"), broken
harness wires, loss of CAN data signal.

EPS fault recovery method:EPS will auto-recover when either
the vehicle speed or engine RPM
signal is restored."
GL

 

[Jonny Wire]

Ok, thanks for the info st96badboy. I never found that but eventually find another thread with someone getting the same sequence of error codes including C 1325 and sounds like we’re most likely looking at a bad ecm or a broken CAN wire in the main harness. Once I get into more I’ll update. Thanks again.

 

[st96badboy]

Ok, thanks for the info st96badboy. I never found that but eventually find another thread with someone getting the same sequence of error codes including C 1325 and sounds like we’re most likely looking at a bad ecm or a broken CAN wire in the main harness. Once I get into more I’ll update. Thanks again.

Yup. Check all of the harnesses. From what I see maybe loss of power to the EPS signal (orange) or faulty sensor in the EPS?

Possibly a bad ground?
GL

 

[bajariders]

Yup. Check all of the harnesses. From what I see maybe loss of power to the EPS signal (orange) or faulty sensor in the EPS?

Possibly a bad ground?
GL

Good to know, since we have an early 2013 HO Limited, thanks.....