Wildcat Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,840 Posts
Mine has the same issue.
 

·
Registered
Joined
·
1,840 Posts
Plug latch facing up. Jumper pins 1, 3 and 4. Did mine yesterday. I tryed to remove the sensor and it would not slide off the shaft. Resorted to prying on it and of cource it broke.
 

·
Registered
Joined
·
1,840 Posts
After all the repeat failures I read about, I installed the jumper and never looked back. It caused me way too many issues just to see what gear I am in. What good is it to know if air can't GO!
 

·
Registered
Joined
·
1,840 Posts
At least the jumper has some positive aspects to it by overriding low and reverse Rev limits, yea
 
1 - 4 of 4 Posts
Top