I needed to replace my ISA so.....

Over the last ten years I've had to replace my ISA control once, and had to pull it a couple times to clean. Every time I do it I think - why didn't they make this easier to access? It's not a terrible job, but it's frustrating taking all the body work off to do the two minute job of replacing or cleaning the ISA. So one more time, I tore the body off to get to the ISA and determined I need a new one. I have a new one on order, but it won't be here until sometime next week. With good weather coming this weekend I want my machine ready to ride (It runs fine once it's warmed up), but I don't want to put it all together then have to tear it all apart again to replace the ISA next week, so what can I do? It's time to make an easy access hole! I used a 4" hole saw to cut a hole in the bed above the ISA, then used a couple pieces of aluminum strap to hold the cutout in place. It's not the prettiest, but I always have a Tusc duffle bag in the back so no one will ever see it anyhow. After I replace the ISA next week I'll seal it up with caulk.