Wildcat Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hello

this is my first post. I have purchased a 2013 wildcat 4 1000 with 1200 km on it. Really clean machine. I’ve put 50 km on it and found the silicone gasket on the bottom end leaks oil in a few spots. Oil level only drops half way down the sip stick then stops leaking. Will it be ok to use like this until I can pull the motor and repair the leaks? This is my first side by side.
There was no sign of the leak when I bought it as it was cleaned really well…..😤
 

· Registered
Joined
·
1,452 Posts
hi- welcome to the club- well so the seller did a good job !?? ;_))

so there where some years with bad casting and a lot oil leaks - if you SEARCH in the forum you will find many posts about!!
1st if its not too cold? i would put in thicker oil 10- 40 summer 20-60
there where some guys havin success with sealin it from outside-
as good as possible- and often look for oillevel!
cause splittin the case to reseal new is not a fast job !? ;- ()

good luck
 

· Registered
Joined
·
1,452 Posts
motorcycle rtv sealants- ive used red dirko and ducati threebond- clean as good as possible!!
ive sealed my old xr 500 from outside this worked for 2 years ;-)

Reply Quote




[IMG alt="Phatcat"]https://www.wildcatforums.net/d1/avatars/m/18/18930.jpg?1580976689[/IMG]
[U]Phatcat[/U]
· Premium Member
Joined Jan 7, 2017
·
1,243 Posts
Discussion Starter · #27 · Mar 14, 2017

well after almost 200 miles on my cat since I worked on it in January....the gray RTV that I put over the problem areas at the case halves are doing well. No Oil on the floor... I had great access with the seats out and starter removed to hit that area and clean it REALLY well. The right rear of the engine I did the same. So far so good. I guess I hope it holds up for a yr or two and then If I have to ......I will repeat until its time for that rebuild.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top