Wildcat Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
872 Posts
Discussion Starter #1
Anyone installed one ?
I saw this one on the Weller site for the YXZ- wonder if it will work on the XX.
Or maybe something simpler- not sure where to mount a pressure sender on the motor.
 

·
Registered
Joined
·
401 Posts
Mine has the Weller sending unit and gauge. Same setup I used on my YXZ.
 

·
Registered
Joined
·
401 Posts
7 at idle while hot 45 to 56 when cold
 

·
Registered
Joined
·
63 Posts
Mine has the Weller sending unit and gauge. Same setup I used on my YXZ.
What is normal PSI for XX?

I been checking out the Weller one and also saw Alba has an oil pressure sensor adapter for the yxz.
So looks like our units have the oil pressure switch in the location the YXZ Alba sensor goes. Might have to get the Weller, want to be able to see what PSI not just get oil psi on dash.

Rode this weekend noticed oil psi on dash at start up for a quick second, have the Alba tune so it starts up sooner than stock.

Are you guys seeing that either on stock or tuned ecu’s?
 

Attachments

·
Registered
Joined
·
872 Posts
Discussion Starter #6
So the Weller unit attaches to the oil filter housing but the Alba unit replaces the stock idiot light sensor?
If you switch that you lose the idiot light?
 

·
Registered
Joined
·
63 Posts
So the Weller unit attaches to the oil filter housing but the Alba unit replaces the stock idiot light sensor?
If you switch that you lose the idiot light?
Not sure if you can remove and replace the stock sensor with out affecting ECU, it states if oil pressure low engine is limited to 4000 rpm.
 
1 - 7 of 7 Posts
Top