Wildcat Forum banner
1 - 2 of 2 Posts

· Registered
23 Posts
Discussion Starter · #1 ·
I need advice on how to remove the upper a-arm from the spindle. I've removed the bolt, I've soaked the stud in WD-40. I've tried using a lever bar to pry the upper a-arm out of the spindle hole with no luck. Perhaps I need to lift the front end with a jack.

Automotive fuel system Motor vehicle Automotive tire Gas Suspension
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.