Wildcat Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I bet there a lot of people with me struggling on this install. Todd from Speed suggested disconnecting the steering shaft pinch clamps from the front and back of the power steering box, also unmount the power steering box (4 bolts). With the shaft free from the power steering it's much easier to remove and reinstall from the rack below. Good luck, the entire job tested my patience, but it's doable.
 

Attachments

·
Registered
Joined
·
134 Posts
I loosened the pinch bolts on both the rack and the power steering box. That allowed enough to slide the shaft up, and then when the rack is loose there was just enough room to pop off...
 

·
Registered
Joined
·
25 Posts
Steering Before.jpg
Steering After.jpg
There is a great video on how to install this kit on the Speed SxS site. Follow it exactly and you won't have any problems. I tried to take a few short cuts and it only cost me more time. I agree, getting access to some of those bolts is a pain though.
251507
 

·
Registered
Joined
·
11 Posts
Fixing to have mine done. I bought the psc rack and having my fabricator make me some mounts


Sent from my SM-N950U using Tapatalk
 
1 - 4 of 4 Posts
Top