Wildcat Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I did a Forum, google, 2019 Shop Manual and you tube search on the above and found nothing. Can anyone point me in thre right direction on where to find XX clutch alignment methods, measurements, tolerances, and proceedures?

I understand there is an alignment bar, looking for less than 1.520 mm gap (?) on the primary clutch as measured from the face of the secondary. I believe you shim between the fixed and moving sheeve on the secondary to get the clutches aligned. But no written data to confirm my thoughts.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
It is discussed in the manual, and you are correct on the shimming
Thank you. By assuming the alignment should be done before the belt is put back on, I expected to see that information between steps 3 and 4 in the assembly of the driven clutch section. I did not scroll down enough.
 
1 - 3 of 3 Posts
Top